VST OneTrack Specifikace stáhnout pdf (Strana 268)

100

101

- 268 -

6. Drag the upper set of arrows to set the start and end points for the fade

of the second ﬁle.

If you want the fade to end later than you indicated when dragging with the

Crossfade tool, you can numerically change the value in the XFade End Pos

value box. You will not be able to go past the start/end points of the entire

Event.

7. Use the mouse to draw the shape of the fade in and fade out curves.

Drawing in the overlapping area only affects the start segment (the fade out).

If you want to change the overlapping part of the fade curve for the end seg-

ment (the fade in), start dragging to the right of the overlap and keep dragging

to the left.

8. As an alternative to drawing, you can use the buttons on each side of the

curve display to select “preset” linear or logarithmic curve types for the

fade in/fade out curves.

The logarithmic curves will create the most natural fade.

9. Click Calculate.

A preview of the crossfade gets created, which you can see in the box below

the curve display.

● Is is quite possible to introduce clipping (levels higher than the system can

handle) with inappropriate fade curves. If this happens, the program will tell

you the number of Clips detected. Adjust the curves and Calculate again!

10.Check the fade using the Play button.

11.When you have a fade you are happy with, click the OK button.

A new Event appears on top of the two you were fading between. This Event

plays a new ﬁle which contains the actual crossfade.

The created crossfade ﬁle(s) are placed in a folder on your recording hard disk,

named “Songname_Xfades” (where “Songname” is the name of the current Song).

12.To ensure the three Events retain their timing relationship even after ed-

iting, they are automatically Grouped.

1 2 ... 263 264 265 266 267 268 269 270 271 272 273 ... 494 495

Komentáře k této Příručce

Žádné komentáře

VST OneTrack Specifikace Strana 268

Komentáře k této Příručce